Dear brethren, please follow
these simple care instructions and enjoy the Word of God!
Magnetic Signs:
Warning: Failure to read this could result in expensive repairs, as sheets
have been known to fuse to the car doors. To prevent this from happening,
regular removal with a light waxing on the car and the rear of the signs
should prevent accidents. If on cold days the sign is very stiff, just hang
it on the side of the refrigerator or filing cabinet, and let it get to room
temperature. This should flatten the sign. The following is some basic
information, which might be of assistance. And pray for us…
Preparation: Be sure that the surface to receive the magnet and the
brown magnet side of the magnet are both free of moisture, dirt, dust, etc.
In a car or truck sign application, it is recommended that the vehicle be
well waxed and some applications may require the use of simple baby powder
on the plain brown magnetic side of the sheet for best results. And always
pray for us…
Application:
Before applying the magnetic sheet, make sure it is allowed to warm up to
room temperature. To apply, allow one edge of the magnetic sheet to contact
the metallic surface at the desired point. The remaining portion of the
sheet should then be allowed to magnetically adhere itself to the metallic
surface. To reposition the magnet do not attempt to pull it into place. This
may cause stretching. Simply remove the entire magnetic sheet, and repeat
the procedure. It is important to make sure the magnetic sheeting is applied
in a smooth, lay-flat fashion. Avoid sharp contours, and DO NOT attempt to
position the magnetic sheet over vehicle moldings or chrome strips. The
entire sheet must be well adhered to the metallic surface to avoid any air
pockets. Oh yes, pray fervently for us…
Maintenance: It
is common for moisture to collect between the magnetic sheet and the
metallic surface. It is important that the sheet be removed at least once a
week, and that both the surface, and the sheet be wiped free of moisture.
Extra caution should be exercised with new vehicle finishes. Failure to do
so may result in damage to the metallic surface, or loss of the sheet at
highway speeds. For cleaning, use a soft cloth, warm water, and a mild
detergent. And remember to pray for us…
